Yamaha RX-V592RDS 18

IPTY SEEK MODE button

When this button is pressed, the unit turns into the PTY SEEK mode.

JPTY SEEK START button

Press this button to begin searching for a station after the desired program type is selected in the PTY SEEK mode.

KEON button

Press this button to select a desired program type (NEWS, INFO, AFFAIRS, SPORT) when you want to call a radio program of that program type automatically.

LFM/AM buttons

Press this button to switch the reception band to FM or AM.

MMEMORY (MAN’L/AUTO FM) button

When this button is pressed, the MEMORY indicator flashes for about 5 seconds. During this period, select a desired preset station number by pressing the corresponding preset station number selector button to enter the displayed station into the memory.

When this button is pressed and held for about 3 seconds, the automatic preset tuning begins. (Refer to page 30 for details.)

NEDIT button

This button is used to exchange the places of two preset stations with each other.

OTUNING DOWN/UP button

Used for tuning. Press the “UP” side to tune in to higher frequencies, and press the “DOWN” side to tune in to lower frequencies.

When this unit is in the PTY SEEK mode, pressing this switch changes the currently selected program type.

PTUNING MODE (AUTO/MAN’L MONO) button Press this button to switch the tuning mode to automatic or manual. To select the automatic tuning mode, press this button so that “AUTO (TUNING)” lights up on the display. To select the manual tuning mode, press this button so that “AUTO (TUNING)” goes off.

QDELAY/CENTER/REAR/SWFR and TIME/LEVEL +/– buttons

Adjust the delay time (DELAY), the center channel output level (CENTER), the rear channel output level (REAR) and the output level to the SUBWOOFER OUTPUT terminal (SWFR). Select the item which you want to adjust by pressing the DELAY/CENTER/REAR/SWFR button and adjust its time or level by pressing the TIME/LEVEL +/– button.

RCENTER MODE button

Selects a center channel output mode (NORMAL, WIDE or PHANTOM). (For details, refer to page 23.)

SVIDEO AUX terminals

Connect an auxiliary video or audio input source unit such as a camcorder to these terminals. If the connected video unit has a S video output terminal, connect it to the S VIDEO terminal to obtain a high resolution picture. The source connected to these terminals can be selected by the corresponding input selector button.