Yamaha RX-V640RDS SOUND 1 SPEAKER SET, speaker mode settings, 1A CENTER center speaker mode, item

6 Press j / i once to enter		PRESET/CH
the setup mode of the	–		+
selected item.		SELECT
The last setting you adjusted
appears on the front panel
display.
Depending on the menu item,		PRESET/CH
press u/d to select a sub	–	SELECT	+
item.
7 Press j / i repeatedly to		PRESET/CH
change the menu item	–		+
setting.		SELECT

8 Press u / d repeatedly until the menu disappears or just press one of the DSP program group buttons to exit from the set menu.

	PRESET/CH			HALL	JAZZ CLUB	ROCK	ENTER-
						CONCERT	TAINMENT
				1	2	3	4
–		+	or	MUSIC	TV	MOVIE	MOVIE
	SELECT			VIDEO	THEATER	THEATER 1 THEATER 2
				5	6	7	8
				/DTS	NIGHT	6.1/5.1	STEREO
				SUR.
				9	0	+10	ENTER
							EFFECT

Memory back-up

The memory back-up circuit prevents the stored data from being lost even if this unit is in standby mode. However, if the power cord is disconnected from the AC outlet, or the power supply is cut for more than one week, the stored data will be lost. If this happens, adjust the items again.

The BASIC and SOUND menus

The “BASIC” menu allows you to easily set the “SOUND 1 SPEAKER SET” and “SOUND 2 SP DISTANCE” parameters. It is not necessary to reset any of the parameters in the “BASIC” menu, but you can access more detailed parameters in the “SOUND” menu if you wish.

Note

•After altering parameters in the “SOUND” menu, if you select “BASIC 1 SETUP” and then select “SET”, the parameters from the “SOUND” menu alter in response to any changes you make in “BASIC 1 SETUP”. Do not enter the “BASIC 1 SETUP” menu unless you wish to change these settings. If you accidentally enter the “BASIC 1 SETUP” menu, select CANCEL to return to the “BASIC” menu. (page 20)

SET MENU

SOUND 1 SPEAKER SET

(speaker mode settings)

Use this feature to select suitable output modes for your speaker configuration.

Note

•Some menu item settings have no effect when the unit is reproducing a source with a digital signal sampling frequency greater than 48 kHz.

■1A CENTER (center speaker mode)

If you add a center speaker to your speaker configuration, this unit can provide better dialog localization for several listeners and superior synchronization of sound and images.

Choices: LRG (large), SML (small), NON (none)

LRG

Select this if you have a large center speaker. The unit directs the entire range of the center channel signal to the center speaker.

SML

Select this if you have a small center speaker. The unit directs the low-frequency signals (90 Hz and below) of the center channel to the speakers selected with “1E BASS”.

NON

Select this if you do not have a center speaker. The unit directs all of the center channel signal to the main left and right speakers.

OPERATION ADVANCED

English

41