GETTING STARTED

Installing batteries in the remote controller

Since the remote controller will be used for many of this unit’s control operations, you should begin by installing the supplied batteries.

1.Turn the remote controller over and slide the battery compartment cover in the direction of the arrow.

2.Insert the batteries (AA, R6, UM-3 type) according to the polarity markings on the inside of the battery compartment.

3.Close the battery compartment cover.

2

1

3

Notes about the remote controller

Battery replacement

If you find that the remote controller must be used closer to the main unit, the batteries are weak. Replace both batteries with new ones.

Notes

●Use AA, R6, UM-3 batteries.

●Be sure the polarities are correct. (See the illustration inside the battery compartment.)

●Remove the batteries if the remote controller is not used for an extended period of time.

●If batteries leak, dispose of them immediately. Avoid touching the leaked material and contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries.

Be sure to insert the new batteries within 2 minutes after you remove the old batteries from the remote controller. If the remote controller is left for more than 2 minutes without batteries, all of the codes you entered will be cleared and the remote controller will return to the factory preset condition.

Remote controller operation range

Remote control sensor

Within approximately 6 m (19.7 feet)

30

°

°

30

Notes

●The area between the remote controller and the main unit must be clear of large obstacles.

●Do not expose the remote control sensor to strong lighting, in particular, an inverter type fluorescent lamp. Otherwise, the remote controller may not work properly. If necessary,

position the main unit away from direct lighting.

8