Remote Control Features

Setting the Manufacturer Code in the Remote Control

You can control other components by setting a manufacturer code. A code can be set up in each component control area except for the OPTN area. The Yamaha code is factory preset for DVD, CD-R, CD, MD, TUNER, and Å (LD code). There is no factory preset code on VCR1, VCR2/DVR, V-AUX, PHONO, TAPE, CABLE, SAT.

1 Select the source component you want to preset by using the input buttons.

English

LEARN

2 Press and hold LEARN for about three seconds using a

 

ballpoint pen or similar object.

 

Flashes

 

 

alternately

 

3 Use h/g to select the name of your component’s manufacturer.

• You will find the names of most audio-video manufacturers worldwide in alphabetical order on the display window.

4 Press POWER (or any other button) on the remote control while pointing it at the component to check if you have set up the code correctly. If the component cannot be controlled by the remote control, try entering another code for the same manufacturer.

5 Press LEARN to confirm the preset.

• If you want to preset another code for another component immediately, press ENTER and repeat steps 1 to 4.

Note:

•If you have already programmed a remote control function to a button, the function takes priority over the set up manufacturer code’s function.

■Controlling a different component from the source component (input) you selected

1 Repeat steps 1 and 2 of the procedure in “Setting the

Manufacturer Code in the Remote Control”.

2 Select a Library (component category) by using q/w.

• There are 13 Libraries to set up a manufacturer code; L:TV, L:CAB (CABLE), L:DBS, L:SAT, L:VCR, L:DVD, L:LD, L:CD, L:MD, L:TAP (TAPE), L:TUN (TUNER), L:CDR, *L:AMP.

* L:AMP has four codes; YPC, DSP, NO, and Zone2. “YPC” should be selected to operate this unit. “DSP” is for operating Yamaha DSP amplifiers other than this unit. “NO” is to clear the main unit control area functions. Zone 2 function is not equipped on this model.

3 Repeat steps 3 and 4 of the procedure in “Setting the

Manufacturer Code in the Remote Control”.

Note:

•“ERROR” appears in the display window in the following conditions: when pressing a button other than the cursor and ENTER; when pressing more than one button at once; and when one of MACRO ON/OFF, 10KEY/DSP, PARAMETER/SET MENU is switched to another position.

51