Yamaha SW-3 CONNECTING TO LINE OUTPUT (PIN JACK) TERMINALS OF THE AMPLIFIER, To connect two units, To connect one unit only, Notes, PRE OUT

CONNECTING TO LINE OUTPUT (PIN JACK) TERMINALS OF THE AMPLIFIER

•Leave the main speakers connected to the amplifier.

•Amplifier line output terminals are generally labeled PRE OUT or SUBWOOFER OUT.

*For PRE OUT terminal connection, the amplifier must possess at least two sets of PRE OUT terminals. With some amplifiers with only one set of PRE OUT terminals, connection can result in no sound from the main left and right speakers. In this case, select the method of connecting to the speaker terminals.

•To connect with a YAMAHA DSP amplifier, connect the LOW PASS (or SUBWOOFER etc.) terminal on the rear of the DSP amplifier to either the left (L) or right (R) INPUT 2 terminal.

To connect one unit only

Left speaker	This unit	Right speaker
	INPUT2	INPUT1
		FROM AMPLIFIER

OUTPUT

TO SPEAKERS

	To AC outlet	<YAMAHA DSP amplifier>		Pin plug cords
			LOW PASS
Amplifier		<Amplifier>
			PRE OUT
To connect two units
Left speaker				Right speaker
INPUT2	INPUT1	INPUT2	INPUT1
	FROM AMPLIFIER		FROM AMPLIFIER

Pin plug cords

OUTPUT	OUTPUT
TO SPEAKERS	TO SPEAKERS

This unit

PRE OUT

Amplifier

To AC outlet

Notes

•When connected to line output terminals of the amplifier, other speakers should not be connected to the OUTPUT terminals on the rear panel of this unit. If connected, they will not produce sound.

•When connecting to a monaural line output terminal of the amplifier, connect to either the left or right INPUT 2 terminal.