Usingthe subwoofer
Subwoofer rear paneE
Pre-adjustino the subwoofer
voJuNle
Before you use the subwoofer, first adjust the vol- ume balance between the subwoofer and the front
speakers by following the procedure below, Set the VOLUME control to minimum (0),
2.Turn on the power to all other components,
3.Press the POWER switch to the ON position, The power indicator on the rear panel lights up in green,
4.Play a source that contains bass signal, Adjust the amplifier's volmne control to the desired lis- tening level,
5.Rotate the VOLUME control gradually to adjust the volume balance between the subwoofer _md the other speakers, To eJ_ioy natural bass sound, keep the subwoofer volume at a level where it is
barely distinguishable from other speakers,
_. Adjust the volmne of the entire sound system
using the amplifier's volume control,
@Power indicator
Lights up in GREEN when the POWER switch
(@)is tnrned ON; turns off when the POWER switch is turned OFF.
@POWER switch
Press this switch to the ON position to turn on the power to the subwoofer. When the power of the subwoofer is on, the power indicator (@) on the rear panel lights up in green. Press this switch again to set it to the OFF position to turn off the power of the subwoofer,
@VOLUNE control
Adjusts the volume level, Tnrn the control clockwise to increase the volume, and counter- clockwise to decrease the volume,
@iNPUT terminal
Input terminal for line level signals from the amplifier,
Note: h is recommended to set the VOLUME control about in the middle
position when using in a multi channel home theater system,
VOLUME
o 1o
4
