Yamaha TSS-1 Troubleshooting

Troubleshooting

Refer to the chart below when the speakers do not function properly. If the problem you are experiencing is not listed below or if the instructions given below do not help, disconnect the AC adaptor and contact your authorized YAMAHA dealer or service center.

		Problem	Cause	What to Do
No sound comes from the speakers or			The AC adaptor is not properly plugged into	Insert the AC adaptor firmly into the AC
subwoofer.			the AC receptacle.	receptacle.
			The power of this system is set to off.	Turn on the power by pressing the power
				switch. (The power indicator lights up.)
			Connections are faulty or incomplete.	Make the connections again.
			Appropriate input mode is not selected.	Select the appropriate input mode by
				pressing the INPUT selector button.
			The volume setting is low.	Turn the MASTER VOLUME control
				clockwise to increase the volume.
			The MUTE function is active. (The indicator	Press the MUTE button to cancel this
			on the left side of the MUTE button is	function. (Some other operations also cancel
			illuminated.)	this function.)
No sound from the surround speakers			The SURROUND level control is set to	Turn the SURROUND level control clockwise
			minimum.	to increase the level.
			No surround mode is selected.	Select the appropriate surround mode by
				pressing the MODE button. If no mode can
				be selected, change the input source to
				another which is encoded with DTS, Dolby
				Digital or Dolby Prologic.
No sound from the center speaker			The CENTER level control is set to minimum.	Turn the CENTER level control clockwise to
				increase the level.
			The SPEAKER MODE switch on the rear	Set the SPEAKER MODE switch to “5CH”.
			panel of the amplifier unit is set to “2CH” or
			“4CH”.
			No surround mode is selected.	Select the appropriate surround mode by
				pressing the MODE button. If no mode can
				be selected, change the input source to
				another which is encoded with DTS, Dolby
				Digital or Dolby Prologic.
No sound from the center and			Dim illumination of an indicator means that	Press the MODE button for the appropriate
surround speakers though the DTS or			signals encoded with the corresponding	surround format. The indicator turns bright,
	DIGITAL mode indicator is		format (DTS or Dolby Digital) is inputted to	and the center and surround speakers output
illuminated.			this system. In this case, the signals are	sounds since the surround format is decoded.
			mixed into 2-channels and outputted from the
			front speakers only.
The		DIGITAL mode indicator is	The input source encoded with Dolby Digital	Check the setting of the digital output on the
dimly illuminated and the			may be originally in 2-channel mode.	player which is sending input signals to this
PROLOGIC mode indicator is brightly				system. If the input source is originally in 2-
illuminated.				channel mode, use the	PROLOGIC mode
				to enjoy the source in a multi-channel mode.
Sound is distorted.			The level of the signal being inputted is too	Turn up the volume on the connected
			low.	component.
Noise.			The level of the signal being inputted is too	Turn down the volume on the connected
			high.	component.
			Connections are faulty or incomplete.	Make the connections again.
			The amplifier unit is near the monitor.	Place the amplifier away from the monitor.

English

E-9