Yamaha TX-670RDS Flashes, Press and, station” on page, To recall a preset station, FM hold for about 3 seconds, With this function, the settings of the

AUTOMATIC PRESET TUNING

You can also make use of an automatic preset tuning function for RDS stations only. By this function, this unit performs automatic tuning and stores RDS stations with strong signals sequentially. Up to 40 stations are stored automatically to the preset station buttons in the same way as in the manual preset tuning method on page 9.

English

1 2

To store stations

1 FM/AM

After the automatic preset tuning is completed

The display shows the frequency of the last preset station. Check the contents and the number of preset stations by following the procedure of the section “To recall a preset

MEMORY

Press andFM hold for about 3 seconds.

station” on page 9.To recall a preset station

Simply follow the procedure of the section “To recall a preset station” on page 9. A recalled station is shown by the frequency or station name on the display.

Notes

FM	MHz	STEREO

		WIDE 0		50	100
MEMORY	AUTO ST		AUTO TUNING

Flashes.3 Slightly turn the TUNING control to the right (or to the left).

*When turned to the right, automatic tuning is performed toward higher frequencies. When turned to the left, automatic tuning is performed toward lower frequencies.

This unit performs automatic tuning and received RDS stations are programmed to A1, A2 ... A8 sequentially.

*If more than 8 stations are received, they are also programmed to other pages (B, C, D and E) of preset station buttons in that order.

●The automatic preset tuning search will be performed through all RDS network frequencies until 40 stations are stored. If the number of received stations is less than 40, the search will stop after searching through all stations.

●With this function, the settings of the MODE, BLEND and IF MODE buttons are stored along with stations.

●With this function, only RDS stations with sufficient signal strength are stored automatically. If the station you want to program is weak in signal strength, tune to it in monaural manually and program it by following the procedure of the section “To store stations” on page 9.

*There may be a case that this function cannot receive a station which could be received by the automatic tuning method. This is because this function receives a large volume of PI (Program Identification) data along with the station.

●You can replace a preset station by another FM or AM station manually by simply following the procedure of the section “To store stations” on page 9.