Registration Memory
Reference
129
TYROS Owner’s Manual
127
3Program the Registration Sequence.
4After setting the REGISTRATION SEQUENCE ENABLE to on, press the [EXIT] button
to return to the Main display and confirm whether the Registration Memory numbers
are called up according to the sequence programmed above.
• Use the [NEXT] button to call up the Registration Memory numbers in the order of the sequence,
or use the [BACK] button to call them up in reverse order. The [BACK]/[NEXT] buttons can only
be used for Registration Sequence when the Main display is called up.
• Use a connected foot pedal to select the Registration Memory numbers in order. The foot pedal can
be used for Registration Sequence no matter which display is called up (except for the display in
step #3 above).
5Call up the Open/Save display for the Registration Memory Bank and save the Regis-
tration Sequence setting as a Registration Memory Bank file.
• When both “Regist (+) Pedal” and
“Regist (-) Pedal” are set to “OFF,”
the pedals cannot be used to step
through the Registration
Sequence; only the [BACK]/
[NEXT] buttons can be used in the
MAIN display.
Turns the Registration Sequence
function on/off. When this is set to
“ON,” the programmed Registra-
tion Sequence is shown at the top
right of the Main display, and you
can step through the sequence in
this display by using the [BACK]/
[NEXT] buttons or the pedal.
Registration Sequence data is
included as part of the Registration
Memory bank file. To store your
newly programmed Registration
Sequence, save the current Regis-
tration Memory bank file (in step #5
below). Any Registration Sequence
data is lost when changing Registra-
tion Memory banks or when turning
the power off, unless you’ve saved it
with the Registration Memory bank
file.
Indicates the file name of the selected
Registration Memory bank.
Determines which pedal is used to advance (increment)
through the sequence.
Determines which pedal is used to reverse (decrement)
through the sequence.
Indicates the Registration Mem-
ory preset numbers, in the order
of the current Registration
Sequence.
Deletes all Registration Memory
numbers in the sequence.
These move the cursor posi-
tion in the sequence. Deletes the number at the cursor position.
Inserts the number of the currently selected Registration
Memory preset immediately before the cursor position.
Replaces the number at the cursor position with the currently
selected Registration Memory number.
The controls in this section
are used for specifying the
order for calling up Regis-
tration Memory number as
a Registration Sequence.
Determines how Registration Sequence behaves when reaching the end of the
sequence.
STOP Pressing the [NEXT] button or the “advance” pedal has no effect.
The sequence is “stopped.”
TOP The sequence starts again at the beginning.
NEXTBANK The sequence automatically moves to the beginning of the next
Registration Memory bank in the same folder.
BACK NEXT BACK NEXT
The Registration Sequence is indicated at the top
of the Main display, letting you confirm the currently
selected number.
When the SEQUENCE END is set to “NEXT
BANK,” the sequence automatically moves to the
beginning of the next Registration Memory bank in
the same folder.
• You can easily resets the Registration Sequence
and go back to the first entry by holding down the
pedal for a few seconds (the red box indicator at the
top right goes out). Press and release the foot
pedal to re-select the first entry in the sequence.