Operation

remove the clip from the engine shut-off switch.

●Do not put your hands in the intake grate.

If the watercraft capsizes, turn it over immedi- ately.

To upright the watercraft:

(1)Remove the clip from the engine shut-off switch.

(2)Swim to the rear of the watercraft. Turn the watercraft over clockwise by pulling on the ride plate with your left hand while pushing down on the gunwale with your right hand or foot.

If the port (left) side of the capsized wa- tercraft is tilting up, push down on the gunwale so that the port (left) side is down before turning the watercraft clock- wise. NOTICE: Do not turn the water-

craft over counterclockwise, otherwise water can enter the engine,

which can result in severe damage.

[ECJ00541]

(3)Start the engine and operate the water- craft at planing speed to drain the bilge water from the engine compartment. (See page 53 for information on draining the bilge water. If the engine does not start, see “Towing the watercraft” on page 93 or “Submerged watercraft” on page 93.) NOTICE: Do not run the en- gine at full throttle for at least 1 minute after the engine has been restarted. Bilge water in the engine compart- ment can splash into the engine, which can result in severe damage.

[ECJ00553]

EJU35962

Beaching and docking the watercraft

To beach the watercraft:

(1)Make sure that there are no boats, swim- mers, or obstacles near the beach.

75