Pairing Input Channels 77
DM1000 Version 2—Owner’s Manual
6
Input Channels
■Pairing Channels by Using the [SEL] Buttons
1While pressing and holding down the [SEL] button for one of the channels
you wish to pair, press the [SEL] button for the adjacent channel. (The paired
channel numbers should be odd and even in this order).
The Channel Pairing window appears.
2Move the cursor to the desired button in the Channel Pairing window, then
press [ENTER].
The following buttons are available in this window:
•CANCEL
Cancels the operation.
•CH x ➔ y
Copies the odd channel parameter values to the even channel.
•CH y ➔ x
Copies the even channel parameter values to the odd channel.
•RESET BOTH
Resets both channel parameters to the default settings (same as when Channel memory #01
is recalled).
Move the cursor to the desired button, then press [ENTER] to confirm the pair.
Note: The settings of the first channel are copied to the second channel and the channels are
paired if the Pair Confirmation check box on the Preference1 page is not checked (default).
(If the selected channels have already been paired, this procedure will cancel the pair setting.)
Note: You can pair only channels that are adjacent, odd-even (in this order) channels. Pressing
the [SEL] button for a non-adjacent channel will be ignored. You cannot pair or cancel a pair
of vertical partners.
Tip: Pressing and holding down the first [SEL] button of the paired channels and pressing
the second [SEL] button cancels the pair.