Bus Outs 81
DM1000 Version 2—Owner’s Manual
7
Bus Outs
7 Bus Outs
This chapter describes how to adjust the DM1000’s Stereo Out and Bus Out parameters.
About Stereo Out
The Stereo Out section receives Input Channel and Bus Out 1–8 signals, mixes them into
two channels, processes them using on-board EQ, compressor, etc., then routes them to two
channel output connectors. The following diagram illustrates the Stereo Out signal flow.
•INSERT
This section enables you to route the Stereo Out signals to external devices via the on-board
connectors or I/O cards, or insert internal effects processors.
•ATT (Attenuator)
This section enables you to attenuate or amplify the level of signals to be input to the EQ.
The attenuator prevents post-EQ signals from clipping or corrects signal levels that are too
low.
•4 BAND EQ (4-band equalizer)
This parametric EQ features four bands (HIGH, HIGH-MID, LOW-MID, and LOW).
•COMP (Compressor)
This dynamics processor can be used as compressor, expander, or limiter. The processor can
be located pre-EQ, pre-[STEREO] fader, or post-[STEREO] fader.
•ON (On/Off)
This button turns the Stereo Out on or off.
•LEVEL
The [STEREO] fader adjusts the Stereo Out output levels.
•Balance
This section enables you to adjust the level balance between the L and R channels of the Ste-
reo Out.
•OUTPUT DELAY (Output delay)
This section delays the output signals. It is mainly used to fine-tune the signal timing.
•METER
This section enables you to switch the metering position of signal levels that are displayed
on the Meter page or by the stereo meter to the right of the screen. (See page 39 for more
information on selecting the metering position.)
Note: By default, the Stereo Out signals are output to OMNI OUT 9–10. However, you can
patch these signals to other output connectors or I/O cards using the Output Patch pages.
OUTPUT PATCH
OUTPUT
DELAY
METER
ATT 4BAND
EQ
INSERT
INSERT
LEVEL
STEREO L
ON
COMP
METER
(Gain Reduction)
BAL
INSERT
Same as stereo master L STEREO R
METER
METER
(Out Meter)
STEREO L
STEREO R
BUS1
BUS2
BUS3
BUS4
BUS5
BUS6
BUS7
BUS8