98 Chapter 8—Aux Sends
DM1000 Version 2—Owner’s Manual
Setting Aux Send Levels
You can adjust the level of signals routed from Input Channels to the corresponding Aux
Out (1–8). To do this, you can either use the Encoders on the top panel or set the parameters
on the screen.
Using the Encoders
1 Press the AUX SELECT [AUX 1]–[AUX 8] buttons to select the sends.
2 Press the ENCODER MODE [AUX] button.
When the ENCODER MODE [AUX] button is turned on, you can rotate the Encoders to
set Aux Send levels.
3 Select a layer that contains the source Input Channels, then rotate the cor-
responding Encoders.
The DM1000 displays the Send level of the currently-selected channel.
Note: If rotating the Encoders seems ineffective, check the Mode and Pre/Post parameters on
the Aux | Send page (see page 99).