Yamaha WK83840 Miscellaneous Setup (Misc) Page

Panel Operation and Displays

Utility Displays

DME64N/DME24N Owner’s Manual 49

Miscellaneous Setup (Misc) Page

This page includes parameters not available in any other

page.

1Scene Store

Determines whether or not scene store operations are

allowed. This parameter can be set to “Enable” or

“Disable.”

Enable: Scene store operations are allowed.

Disable: Scene store operations are prohibited.

Edit using the “List Parameters” editing procedure

described on page 38.

2Last Mem. Resume

This parameter displays and determines whether the

DME64N/DME24N will recall the current scene when

started up, or whether the memory contents at the time the

unit was turned off will be recalled. The possible settings

are “ON” or “OFF”.

ON: The memory contents at the time the unit was

turned off will be recalled at startup.

OFF: The current scene will be recalled at startup.

If “Last Mem. Resume” is set to ON, the unit will back up

data to the internal memory periodically. In this case, do

not turn off the power to the unit within ﬁve (5) seconds

after you operate any parameters.

3Event Scheduler

Determines whether an event schedule setup in the DME

Designer will be executed or not, and displays the current

status. This parameter can be set to “ON” or “OFF.”

ON: The event will be executed.

OFF: The event schedule will not be executed.

Edit using the “List Parameters” editing procedure

described on page 38.

4Internal HA Ctrl (Internal head amp control)

Determines the connector that will be used to control the

internal head amp.

From a single digital mixer, you can control the internal

head amps of multiple DME series units within the device

group.

Set this parameter only on the DME series unit that is

connected directly to the digital mixer, and turn it “OFF”

for other units.

Edit using the “List Parameters” editing procedure

described on page 38.

OFF: Set this “OFF” if a digital mixer is not connected

directly.

Remote: The internal head amp will be controlled from

the digital mixer via the [REMOTE] connector.

Slot1{Slot1–Slot4 (DME64N)}: The internal head

amp will be controlled from the digital mixer via the

selected slot.

5Remote

Determines the [REMOTE] connector communication

mode.

Edit using the “List Parameters” editing procedure

described on page 38.

Displays the settings of the [REMOTE] terminal.

HA Control (422)

Allows remote head amp control.

Always use this setting when a remote head amp unit

(AD8HR, AD824) is connected. Also, don’t change the

setting while a remote head amp is connected. Doing so

can damage the unit.

COM (232C)

Allows control of DME64N/DME24N units from AMX

and Crestron type external controllers using DME

Communication Protocol*.

NOTE

The Remote setting (2) will not appear on the ICP1 control

panel display.

NOTE

This item cannot be set if Internal HA Ctrl is set to Remote.

NOTE

This setting applies to individual devices only. Even if one

DME64N/24N unit is set to “Disable,” scene store operations

will be possible via another DME64N/24N in the same device

group that is set to “Enable.”

NOTE

This parameter can be changed from the device group master

only.

CAUTION

NOTE

This parameter can be changed from the device group master

only.

NOTE