AE00786

Battery Charging

NOTE:

The generator DC rated voltage is 12V.

1.Wind the battery charging lead (furnished as an accessory) 2 or 3 turns around the frame and plug into DC receptacle.

NOTE:

9Make connections to the battery after starting the

engine.

9 Clamp the red wire to the positive (+) terminal and

761-006the black wire to the negative (-) terminal of the battery. Do not reverse these positions.

1 Red

2 Black

2. Start the engine.

3. Press in the DC protector and install the battery.

cC

w

q

763-005a

9Be sure the economy control switch is turned off while charging the battery.

9Be sure the battery leads are properly connect- ed.

9Be sure the breather hose is properly connect- ed and is not damaged or obstructed.

9Reduce the load to the specified generator rated output if the DC protector turns off. If it turns off again, consult a Yamaha dealer.

NOTE:

Press to reset the DC protector.

1“ON”

2 “OFF”

NOTE:

9At full charge, electrode specific gravity is between 1.26 and 1.28.

9Check specific gravity hourly.

– 19 –