TROUBLESHOOTING

If the unit fails to operate normally, check the following points to determine whether the fault can be corrected by the simple measures suggested. If it cannot be corrected, or if the fault is not listed in the SYMPTOM column, disconnect the power cord and contact your authorized YAMAHA dealer or service center for help.

SYMPTOM

PROBABLE CAUSE

REMEDY

The player does not switch ON when the

The power cord is not connected or not

Securely connect the power cord.

POWER switch is pressed.

completely connected.

 

The disc tray does not close completely.

A foreign object is obstructing the tray.

Carefully check the disc tray and remove the

 

 

foreign object.

 

 

 

The DISC indicator does not illuminate.

The disc has been loaded upside down.

Load the disc correctly.

 

The disc is damaged.

Check the disc carefully; replace it if

 

 

necessary.

 

 

 

 

There is moisture on the laser pickup.

Wait 20 to 30 minutes after switching the unit

 

 

ON before trying to play a disc.

 

 

 

Play does not begin.

The disc has been loaded upside down.

Reload the disc with the label side up.

 

 

 

 

The disc is dirty.

Clean the disc.

 

 

 

Play is delayed, or begins at the wrong

The disc may be scratched or damaged.

Check the disc carefully; replace it if

place.

 

necessary.

No sound.

Improper output cable connections.

Connect the cables properly. If the problem

 

 

persists, the cables may be defective.

 

 

 

 

Improper amplifier operation.

Set the amplifier controls to the correct input

 

 

selection.

 

 

 

Sound “skips”.

The player is being subjected to vibrations or

Relocate the player.

 

impacts.

 

 

 

 

 

The disc is dirty.

Clean the disc.

 

 

 

Sound “hums”.

Improper cable connections.

Securely connect the audio cables. If the

 

 

problem persists, the cables may be defective.

 

 

 

Noise from a nearby tuner.

The tuner is too close to the player.

Move the tuner and player farther apart.

 

 

 

Noise from inside of the disc tray.

The disc may be warped.

Replace the disc.

 

 

 

The remote control transmitter does not

Direct sunlight or lighting (of an inverter type

Change position of the main unit.

work.

of flourescent lamp etc.) is striking the remote

 

 

control sensor of the main unit.

 

 

 

 

SPECIFICATIONS

AUDIO SECTION

Frequency response .....................10 Hz 1 20 kHz, 50.5 dB

De-emphasis equalization ........................................

50.5 dB

Harmonic distortion + noise .........................

0.003% (1 kHz)

S/N ratio ........................................................................

108 dB

Dynamic range ...............................................................

98 dB

Wow & flutter ...................................................

Unmeasurable

Output voltage.................................................

2.050.5V max.

Headphones output (–20 dB) ............

200540 mV/150 ohms

GENERAL

Power requirements

 

U.S.A. and Canada models

................................. 120V, 60 Hz

Australia and U.K. models

.................................. 240V, 50 Hz

Europe model ......................................................

230V, 50 Hz

General model ...........................

110/120/220/240V, 50/60 Hz

Power consumption ........................................................

20W

Dimensions (W x H x D) ...........................

435 x 96 x 267 mm

 

(17-1/8” x 3-3/4” x 10-1/2”)

Weight .......................................................

3.8 kg (8 lbs. 6 oz.)

Accessories ...................................................

Connection cord

 

Remote control transmitter

 

Batteries (size AA, R6, UM-3)
Please note that all specifications are subject to change without notice.

17