Yamaha PSR-E323, YPT-320 Turn on the power, Using the music rest, Removing the protective lm

Setting Up

PSR-E323/YPT-320 Owner’s Manual 9

Setting Up

Make all necessary connections BEFORE turning the power on.

You can connect the PHONES/OUTPUT jack to a set

of headphones, keyboard ampliﬁer, stereo system,

mixer, tape recorder, or other line-level audio device

to send the instrument’s output signal to that device.

The internal speakers are automatically shut off when

a plug is inserted into this jack. The PHONES/OUT-

PUT jack also functions as an external output.

The sustain function lets you produce a natural sustain

as you play by pressing an optional footswitch. Plug

the Yamaha FC4 or FC5 footswitch into the SUSTAIN

jack and use it to switch sustain on and off.

Turn down the volume by turning the [MASTER

VOLUME] control to the left and press the

[STANDBY/ON] switch to turn on the power. While

playing the keyboard, adjust the volume level by using

the [MASTER VOLUME] control. Pressing the

[STANDBY/ON] switch again turns the power off.

Remove the transparent protective ﬁlm that was

applied to the display prior to shipment from the fac-

tory.

Audio Connections —

Headphones and External Equipment

Connecting a footswitch

•Avoid listening with the headphones at high volume for

long periods of time; doing so may not only result in ear

fatigue, it may be damaging to your hearing.

CAUTION

•To prevent damage to the speakers, set the volume of the

external devices at the minimum setting and turn power

off the devices before connecting them. Failure to

observe these precautions may result in electric shock or

equipment damage. Also, be sure to set the volumes of all

devices at their minimum levels and gradually raise the

volume controls while playing the instrument to set the

desired listening level.

CAUTION

• Make sure that the footswitch plug is properly connected to

the SUSTAIN jack before turning on the power.

• Do not press the footswitch while turning the power on. Doing

this changes the recognized polarity of the footswitch, result-

ing in reversed footswitch operation.

NOTE

Turn on the powerUsing the music restRemoving the protective ﬁlm

•When using a power adaptor, even when the power is off,

a small amount of electricity is still being consumed by

the instrument. When you are not using the instrument for

a long time, make sure to unplug the AC power adaptor

from the wall AC outlet, and/or remove the batteries from

the instrument.

CAUTION

Insert the music

rest into the slots

as shown.