ADJUSTING VOLUME

Front panel

YST-SW150

POWER

HIGH CUT

VOLUME

40 Hz

140 Hz

0

10

 

 

 

 

2

5

1, 4

Rear panel

OUTPUT

TO SPEAKERS

FROM AMPLIFIER

INPUT1

1 Set the VOLUME control to minimum.

2 Turn on the power supply to all the components.

3 Play any source and adjust the amplifier’s volume control to the desired listening level.

4 Turn up the VOLUME control gradually to adjust the volume balance between this unit and the main speakers.

5 Adjust the HIGH CUT control to the position where the desired response can be obtained.

6 Set the PHASE switch to the position (NOM or REV)

where the optimum bass effect can be obtained.

YST-SW80

POWER

HIGH CUT

VOLUME

50 Hz

150 Hz

0

10

 

 

 

 

2

5

1, 4

INPUT2 AUTO PHASE

POWER

ON OFF NOM REV

6

Notes

•Once the volume balance between this unit and the main speakers is adjusted, you can adjust the volume of your whole sound system by using only the amplifier’s volume control.

•For adjusting the VOLUME control, the HIGH CUT control and the PHASE switch, refer to “FREQUENCY CHARACTERISTICS” on the next page.

For effective adjustment of the HIGH CUT control

First set this control at about the main speakers’ rated minimum reproduceable frequency. Then turn up the VOLUME control gradually and set it at a level where you can obtain a little more bass effect than when this unit is not used. On the basis of this setting, if desired, adjust the VOLUME control and the HIGH CUT control again.

*The main speakers’ minimum reproduceable frequency can be looked up in the speakers’ catalog or owner’s manual.

9