CONTROLS AND THEIR FUNCTIONS
English
Front panel
| STANDBY/ON | HIGH CUT |
| 40 Hz | 140 Hz |
~ Ÿ !
Rear panel
YST-SW90
| VOLUME | STANDBY/ON | HIGH CUT | VOLUME |
0 | 10 |
|
| 50 Hz |
| 150 Hz 0 |
| 10 |
|
|
|
|
|
|
|
|
|
⁄ | ~ Ÿ | ! | ⁄ | |||||
POWER
ON
OFF
@
OUTPUT | INPUT2 |
TO SPEAKERS
FROM AMPLIFIER
INPUT1
AUTO
STANDBY
LOW HIGH
OFF
¤
PHASE BASS
NOM REV MOVIE MUSIC
#‹
~Power indicator
Lights up while this unit is ON.
*If the AUTO STANDBY switch on the rear panel is set to the LOW or HIGH position, this indicator is illuminated dimly when no signal is input to this unit.
ŸSTANDBY/ON button
Each press of this button turns the unit on and off (on standby). A small amount of power is always consumed even while this unit is on standby.
!HIGH CUT control
Adjusts the high frequency cut off point.
Frequencies higher than the frequency selected with this control are all cut off (and not output).
⁄VOLUME control Adjusts the volume level.
@Main POWER switch
Normally, leave this switch to the ON position. When you will not use this unit for a long period, set this switch to the OFF position.
¤AUTO STANDBY switch
With this switch, you can activate the Automatic Standby function. Normally, set the switch to the LOW position.
To cancel this function, set the switch to the OFF position.
*Change the setting of this switch only when the power of this unit is on standby (by setting the STANDBY/ON button to OFF).
Automatic Standby function
When you play a source, the power of this unit turns on automatically by sensing audio signals input to this unit. This unit turns into the standby mode automatically if the source being played is stopped or the low frequency input signal is cut off for several minutes.
This function will operate by sensing a certain level of low frequency input signal. Its sensitivity is high in the HIGH position and low in the LOW position of the AUTO STANDBY switch. In the HIGH position, the power will turn on even with a low level of input signal, but on the other hand this unit may not turn into the standby mode when there is an input signal even if its level is extremely low.
*There may be a case that the power turns on unexpectedly by sensing noise from other appliances. If it occurs, set the AUTO STANDBY switch to the OFF or LOW position.
*The level of low frequency input signal differs with each
source, and each different part on the same source. So, this function may not operate properly depending on some sources.
This function is available only when the power of this unit is on (by setting the STANDBY/ON button Ÿ to ON).
#PHASE switch
Normally this switch is to be set to the REV (reverse) position. However, according to your speaker systems or the listening condition, there may be a case when better sound quality is obtained by setting this switch to the NOM (normal) position. Select the better position by monitoring the sound.
‹BASS switch YST-SW160 only
By setting this switch to the MOVIE position, the bass sound in video software is well reproduced. By setting it to the MUSIC position, the bass sound in audio software is well reproduced.
7
