CONTROLS AND THEIR FUNCTIONS
Front panel
Rear panel
(General model)
1Power indicator
Lights up in green while the subwoofer is on. Lights up in red while the subwoofer is set in the standby mode by the operation of the automatic power- switching function.
Goes off when the subwoofer is set in the standby mode.
2STANDBY/ON button
Press this button to turn on the power when the POWER switch is set in the ON position. (The power indicator lights up in green.)
Press again to set the subwoofer in the standby mode. (The power indicator goes off.)
Standby mode
The subwoofer is still using a small amount of power in this mode.
3B.A.S.S. (Bass Action Selector System) button When this button is pressed in to the MUSIC position, the bass sound in audio software is well reproduced. By pressing the button again so that it pops out at the MOVIE position, the bass sound in video software is well reproduced.
4HIGH CUT control
Adjusts the high frequency cut off point. Frequencies higher than the frequency selected by this control are all cut off (and no output).
*One graduation of this control represents 10 Hz.
5VOLUME control
Adjusts the volume level. Turn the control clockwise to increase the volume, and counterclockwise to decrease the volume.
6VOLTAGE SELECTOR switch
(China, Korea, Asia and General models only)
If the preset setting of the switch is incorrect, set the switch to the proper voltage (110V, 120V, 220V or
Consult your dealer if you are unsure of the correct setting.
WARNINGBe sure to unplug the subwoofer before setting the VOLTAGE SELECTOR switch correctly.
7POWER switch
Normally, set this switch to the ON position to use the subwoofer. In this state, you can turn on the subwoofer or turn the subwoofer into the standby mode by pressing the STANDBY/ON button. Set this switch to the OFF position to completely cut off the subwoofer’s power supply from the AC line.
9