Yard-Man 203 manual Maintenance, Removing The Flail Screen

Customer Responsibilities

MAINTENANCE

SCHEDULE

UDORPCT	Lubricate Wheels
	Lubricate Adjustment Levers
	Lubricate Caster Wheels
	Check Chipper Blades
	Check Oil
EN	Change Oil
	Check Air Filter
IGN	Clean Engine
E
	Check Spark Plug

u

s

e

h

c

a

e

e

r

f

o

B

e

				y	2	5
			r
		e
	v
E

u

r

s

u

r

s

u

r

s

s

o

n

a

g

e

o

h

o

h

o

e

a

o

r

h

0

0

s

s

t

5

0

a

e

y

1

e

r

r

y

o

e

r

c

f

E

v

v

e

O

n

B

e

E

SERVICE

DATES

Maintenance

•Clean the screen by scraping or washing with water and reinstall the screen.

Engine

Refer to the separate engine manual for all engine maintenance instructions.

•Check engine oil level before each use as instructed in the separate engine manual packed with your unit. Read and follow instructions carefully.

•Clean air cleaner every 25 hours under normal conditions or once a season. Clean every few hours under extremely dusty conditions. To service the air cleaner, refer to the separate engine manual packed with your unit.

•The spark plug should be cleaned and the gap reset once a season. Check engine manual for correct plug type and gap specifications.

Removing The Flail Screen

If the discharge area becomes clogged, remove the flail screen and clean area as follows:

•Stop the engine and make certain the chipper shredder vacuum has come to a complete stop.

•Disconnect spark plug wire from spark plug and ground against the engine.

•Remove the vacuum bag from the unit.

•Remove the four self-tapping screws from the bottom of the discharge chute, and the hex bolt, flat washer and hex nut from the top. Remove the discharge chute assembly. See Figure 10.

•Remove the two hex bolts and hex nuts which extend through the impeller housing. Lift the flail screen from the inside the housing. See Figure 10.

NOTE: Be certain to reassemble the flail screen with the curved side down.

Hex Bolt
Flat Washer
Hex Nut
Discharge
Chute
Self-Tapping
Screws
Hex Bolts	Flail Screen
Hex Nuts

Figure 10

•Reattach the discharge chute assembly with the hardware previously removed and connect the bag to unit.

10