2.With the drive control released, there must be 1/8” clearance between the friction wheel and the drive pulley in all positions of the shift lever.
3.With the drive control engaged, the friction wheel must contact the drive pulley.
4.If adjustment is necessary, loosen the lower hex nut on the drive cable index bracket and pivot the bracket upward or downward as necessary. Refer to Figure
5.Reassemble the frame cover and return the unit back to its operating position.
NOTE: If you placed plastic under the gas cap, be certain to remove it now.
Skid Shoes
The space between this shave plate and the ground can be adjusted. For close snow removal, place skid shoes in the low position. Use middle or high position when area to be cleared is uneven.
1.Adjust skid shoes by loosening the four lock nuts and carriage bolts and moving skid shoes to desired position. See Figure
2.Make certain the entire bottom surface of skid shoes are against the ground to avoid uneven wear on the skid shoes.
3.Tighten nuts and bolts securely.
NOTE: Units are equipped with reversible skid shoes and may be turned over to increase their lifespan. If steel shoes are turned they must also change sides to ensure the “A” on the shoe is towards the front of the unit.
Auger Control
To adjust the auger control, refer to page 13.
Figure 5-4 - Reversible Plastic Skid Shoe
Figure 5-5 - Reversible Steel Skid Shoe
5
Making
Adjustments
IMPORTANT
It is not recommended that you operate this snow thrower on gravel as loose gravel can be easily picked up and thrown by the auger causing personal injury or damage to the snow thrower.
If for some reason, you have to operate the snow thrower on gravel, keep the skid shoe in the highest position for maximum clearance between the ground and the shave plate.
15
