Outer Spool

Spring

Inner Reel

Figure 19

Indexing Teeth

Figure 20

Slotted Holes

For Use with

 

For Use with SplitLine or

Single Line ONLY

 

Single Line

 

 

 

Figure 21

Single Line Installation

Go To Step 8 for SplitLine™ Installation

6.Take approximately 25 feet (7.6 m) of new trim- ming line, loop it into two equal lengths. Insert each end of the line through one of the two holes in the inner reel. Pull the line through the inner reel so that the loop is as small as possible. See Figure 22.

7.Wind the lines in tight even layers, onto the reel. Wind the line in the direction indicated on the inner reel. Place your index finger between the two lines to stop the lines from overlapping. Do not overlap the ends of the line. See Figure 23. Proceed to step 11.

SplitLine™ Installation

8.Take approximately 12 feet (3.65 m) of new trim- ming line. Insert one end of the line through one of the two holes in the inner reel. Pull the line through the inner reel until only about 4 inches is left out. See Figure 24.

9.Insert the end of the line into the open hole in the inner reel and pull the line tight to make the loop as small as possible, See Figure 24.

10.Before winding, split the line back about 6 inches.

11.Wind the line in tight even layers in the direction indicated on the inner reel.

NOTE: Failure to wind the line in the direction indi- cated will cause the cutting attachment to operate incorrectly.

Loop

Figure 22

Figure 23

Loop

Figure 24

15

Page 15
Image 15
Yard Machines 41AD-280G000 manual Single Line Installation, Go To for SplitLine Installation