12.Insert the ends of the line into the two holding slots. See Figure 25.
13.Insert the ends of the line through the eyelets in the outer spool and place inner reel with spring inside the outer spool. See Figure 26. Push the inner reel and outer spool together. While holding the inner reel and outer spool, grasp the ends and pull firmly to release the line from the holding slots in the spool.
NOTE: The spring must be assembled on the inner reel before reassembling the cutting attachment.
14.Hold the inner reel in place and install the Bump Knob by turning clockwise. Tighten securely.
Installing a Prewound Reel
1.Hold the outer spool with one hand and unscrew the Bump Knob counterclockwise. Inspect the bolt inside the Bump Knob to make sure it moves freely. Replace the Bump Knob if damaged. See Figure 18.
2.Remove the old inner reel from the outer spool. See Figure 19.
3.Remove the spring from the old inner reel. See Figure 19.
4.Place the spring in the new inner reel.
NOTE: The spring must be assembled on the inner reel before reassembling the cutting attachment.
5.Insert the ends of the line through the eyelets in the outer spool. See Figure 26.
6.Place the new inner reel inside the outer spool. Push the inner reel and outer spool together. While holding the inner reel and outer spool, grasp the ends and pull firmly to release the line from the holding slots in the spool.
7.Hold the inner reel in place and install the Bump Knob by turning clockwise. Tighten securely.
Replacement Parts:
Refer to PARTS LIST in Section 9.
Holding Slots
Figure 25
Spring
Figure 26
SECTION 7: OFF SEASON STORAGE
If the unit will be stored for an extended time,
1.Drain all fuel from the fuel tank into a container. Do not use fuel that has been stored for more than 60 days. Dispose of the old fuel in accordance to local regulations.
2.Start the engine and allow it to run until it stalls. This ensures that all fuel has been drained from the carburetor.
3.Allow the engine to cool. Remove the spark plug and put 1 oz. (30 ml) of high quality motor oil into the cylinder. Pull the starter rope slowly to distribute the oil. Reinstall the spark plug.
NOTE: Remove the spark plug and drain all of the oil from the cylinder before attempting to start the unit after storage.
4.Thoroughly clean the unit and inspect for any loose or damaged parts. Repair or replace damaged parts and tighten loose screws, nuts or bolts.
The unit is ready for storage.
•Never store the unit with fuel in the tank where fumes may reach an open flame or spark.
•Allow the engine to cool before storing.
•Store the unit in a locked up area to prevent unauthorized use or damage.
•Store the unit in a dry, well ventilated area. Do not store next to corrosive materials, such a fertilizer.
•Store the unit out of the reach of children.
16
