Yard Machines 699 Lubrication, Steeringshaft, BRAKEADJUSTMENT See figure, Steering Gears, Linkage

Models: 690 699

1 20
Download 20 pages 44.02 Kb
Page 12
Image 12
BRAKEADJUSTMENT (See figure 13)

BRAKEADJUSTMENT (See figure 13)

The brake is located by the right rear wheel ir side the frame. The brake has been set at the factoly to the proper clearance. During normal operation of this machine, the brakes are subject to wear and will require periodic examination and adjustment.

running when you adjust the brake..

WARNING: Do not have the engine

To adjust the brake, adjust the nut so the brat:e starts to engage when the brake lever is 1/4" to 5/1 3" away from the axle housing.

Lever

LUBRICATION

&WARNING: Always stop engine and dis- connect spark plug wire before cleaning,

lubricating or doing any kind of work on lawn tractor.

STEERING GEARS

Lubricate teeth of steering gears with automotive multi-purpose grease after every 25 hours of operation or once a season. See figure 14.

STEERINGSHAFT

Lubricate steering shaft at least once a season with light oil.

_'__.Steerirng

!

'_ _ Disc

\ - Brake

1

\

FIGURE 13.

CARBURETORADJUSTMENTS

WARNING: If any adjustments are rmde to the engine while the engine is running

(e.g. carburetor), disengage all c utches and blades. Keep clear of all tnoving parts. Be careful of heated surfacss and muffler.

Minor carburetor adjustments may be reqL ired to compensate for differences in fuel, temperature, altitude and load. Refer to separate engine "nanual for carburetor adjustment information.

NOTE: A dirty air cleaner will cause an engine: to run rough. Be certain air cleaner is clean and atta _hed to the carburetor before adjusting carburetor.

FIGURE 14.

HYDROSTATICTRANSMISSION

The hydrostatic transmission is filled at the factory and does not require checking. If repairs are needed, con- tact your local service dealer. (Hydrostatic transmis- sion contains approximately 2.5 quarts of SAE 20W50 oil.)

LINKAGE

Once a season lubricate all the pivot points on the clutch, brake and lift linkage with SAE 30 engine oil.

WHEELS

The front wheels are provided with grease fittings. The rear wheels must be removed from the axle for lubrica- tion. Lubricate at least once a season with automotive

multi-purpose grease.

PIVOT POINTS

Lubricate all pivot points with light oil at least once a season.

BALLJOINTS

The ball joints and drag link ends are permanently lubricated.

12

Page 12
Image 12
Yard Machines 699 Lubrication, Steeringshaft, BRAKEADJUSTMENT See figure, Steering Gears, Carburetoradjustments, Linkage