•If the paper can be inserted through the coils of the brake spring, the brake is properly adjusted.
•If the paper cannot be inserted, tighten the hex lock nut until the paper can be inserted through the coils.
•Release the parking brake and place the tractor in neutral. Depress the
Hex Lock Nut
Paper
DiscSpring
Brake
Figure 24
CARBURETOR ADJUSTMENTS
WARNING: If any adjustments are made to the engine while the engine is running (e.g. carburetor), disengage all clutches and blades. Keep clear of all moving parts.
Be careful of heated surfaces and muffler.
Minor carburetor adjustments may be required to compensate for differences in fuel, temperature, altitude and load. Refer to separate engine manual for carburetor adjustment information.
NOTE: A dirty air cleaner will cause an engine to run rough. Be certain air cleaner is clean and attached to the carburetor before adjusting carburetor.
SECTION 9: SERVICE
WARNING: Always stop engine and disconnect spark plug wire(s) before cleaning, lubricating or doing any kind of work on garden tractor.
STEERING GEARS
Lubricate teeth of steering gears with automotive multi- purpose grease after every 25 hours of operation or once a season. Refer to Figure 23.
STEERING SHAFT
Lubricate steering shaft at least once a season with light oil.
TRANSAXLE
The transaxle is lubricated and sealed at the factory and does not require checking. If disassembled for any reason, lubricate with 32 oz. of Shell Darina grease, part number
LINKAGE
Once a season lubricate all the pivot points on the clutch, brake and lift linkage with SAE 30 engine oil.
WHEELS
The front wheels may be provided with grease fittings. Lubricate at least once a season with automotive multi- purpose grease.
PIVOT POINTS
Lubricate all pivot points with light oil at least once a season.
BALL JOINTS
The ball joints and drag link ends are permanently lubricated.
BLADE SPINDLES
The blade spindles on the cutting deck are permanently lubricated.
21
