| SERVICE | |
CUTTERHOUSINGSPINDLEASSEMBLYS |
|
|
The cutter housing assembly is designed with a slip fit |
| Cutter housing assemblys use sealed bearings and |
inner race and pulley. The sole purpose of the setscrew |
| are maintance free. |
in the pulley is to hold the housing assembly together. |
|
|
The setscrew is not ment to secure the pulley. The |
|
|
pulley is secured by pinching the pulley to the inner race |
|
|
| NOTE | |
of the bearings using the blade bolt and nut. Tighten the |
| |
setscrews after you have pinched the assembly together |
| WHENPRESSINGABEARINGINOROUTOFA |
with the blade bolt and nut. |
| CUTTERHOUSINGAPPLYCONSTANT |
|
| PRESSURETOTHERACEORRACESTHAT |
Each cutter spindle on 48" Models have a different stack |
| HAVEANINTERFERENCEFIT. |
up of spacers and pulleys, to achieve proper belt |
| NEVERBEATABEARINGINOROUT. |
alignment. The left cutter spindle on 48" Models is the |
|
|
|
| |
same as 32" and 36" Models. See figure #8 (Refer to |
|
|
the Kutter parts manual when ordering parts.) |
|
|
12
