Epson 7000 Removing the CR Motor/Pulley Assembly, CR Timing Belt Motor Four screws, Belt Shaft

EPSON Stylus Pro 7000 Revision B

4.2.3.11 Removing the CR Motor/Pulley Assembly

1.Remove the R Side Cover as described in “R Side Cover Removal” on page 114.

2.Remove the L Side Cover as described in “L Side Cover Removal” on page 116.

3.Remove the Rear Cover as described in “Rear Cover Removal” on page 118.

4.Remove the CR Motor cable from the C299MAIN board connector (refer to Table 4-4, “C299MAIN Board Connectors,” on page 123 for details) and harness clamps. Then pull out the cable through the L Side frame opening.

5.Push down the cutter to release the CR lock and move the carriage away from the home position.

C H E Before loosening the CR timing belt tension, confirm and write

P O I down the current tension. See “CR Timing Belt Tension

Adjustment” on page 198 for information on confirming the

tension.

7.Pull off the CR Timing Belt from the CR Motor pulley on the left side of the printer.

8.Remove the four screws (CP(W) M4x10) securing the CR motor and remove the CR motor.

CR Timing

Belt

CR

Motor

Four screws

Figure 4-60. CR Motor Removal

6. Loosen the CR Tension shaft on the right side of the printer to release the

tension on the CR Timing belt.

CR Timing	CR Tension
belt	shaft

A D J U R E Q U

C A U

When removing the CR Motor, the following adjustment procedures are required.

„“CR Timing Belt Tension Adjustment” on page 198

When reassembling the CR Motor and pulley, move the carriage back-and-forth by hand to make sure the timing belt is exactly in the middle of the pulley and evenly rotating.

Figure 4-59. Loosening the CR Tension Belt

Disassembly & Assembly Disassembly Flow 141