Epson 7000 Head GAP Adjustment, Head Gap Adjustment Items, Gap Check End, #10 #11 #12

One press = 1/2880 inch

"+" = toward HP and "-" = away from HP Black and light cyan lines are vertically aligned

EPSON Stylus Pro 7000 Revision B

HEAD GAP ADJUSTMENT

This function corrects the gap between the B head and the C head. The adjustment pattern is printed in one direction, and referring to the printed test patterns, you can correct any gap between the heads. The adjustment items are as follows.

Table 5-12. Head Gap Adjustment Items

Item	Description	Number
Gap/200/N	Gap adjustment/200cps/Normal-Dot	9
Gap/200/M	Gap adjustment/200cps/Micro-Dot	10
Gap/300/N	Gap adjustment/300cps/Normal-Dot	11
Gap/300/M	Gap adjustment/300cps/Micro-Dot	12

Note: The number refers to the numbered pattern on the printed Bi-D test pattern.

1.Make sure "Adj: Head LR Adj." appears in the LCD, and press the Enter

button. After all the patterns print, "Gap, 200, N: vvv" appears in the LCD.

Please Set Paper

Printing Pattern

Gap XXX Y:	0	XXX= "300" or "200"/
		Y="N" or "M"

Based on the printed pattern, make sure each numbered pattern is aligned.

	[Enter]	End
Gap Check End		adjustment/
		next menu

[SelecType]/[Item]

Figure 5-30. Head Gap Adjustment Operation

#9

#10

#11

#12

Figure 5-31. Gap Adjustment Test Pattern

2.At this point, you need to check the alignment of the lines on the printed test pattern.

„If the lines are correctly lined up as in the above sample, (make sure "Gap Check End" appears in the LCD and) press the Enter button to finish.

„If some lines are not aligned, select the numbered pattern using the

Paper Feed +/- buttons.

Correction distance:

Correction direction:

Aim =

After you finish correcting a pattern, press the Enter button to print another test pattern of that number only with your new settings in effect.

3.Repeat the steps until all numbered patterns are aligned.

Adjustment Self-Diagnostic Mode Menus 187