Epson 7000 service manual Panel Display Priority

EPSON Stylus Pro 7000 Revision B

Table 1-29. Control Panel Messages (continued)

Display Message	Meaning
	When trying to print a test or adjustment
	pattern, one of the following occurs:
UNABLE TO PRINT	• Paper not loaded
	• Ink cartridge not loaded
	• Paper detection error
	• The paper was loaded too far forward and
	cannot be backward fed to the proper
	position.
	• The paper’s horizontal position exceeds the
	normal printable area when the paper is
RELOAD PAPER	loaded.
	• The paper’s horizontal position exceeds the
	normal cutting area after printing.
	• The cut sheet is too long and cannot be
	ejected properly.
	• Recovery from cutter error.
REMOVE PAPER	Loaded paper is too thick to perform timer
	cleaning
PAUSE	Pause state.
	When total dots fired = 90%, cartridge enters
INK LOW	near-end condition. Remaining ink = A1 at
	100% duty
MAINTENANCE REQ. nnnn	Printer requires maintenance - see
	“Maintenance Request” on page 47
PRINTING *	Processing print data.
	• No paper loaded
	• End of roll paper (printer stops feeding)
PAPER OUT	• End of sheet paper (when paper feeds to
	eject position, put hand under the sheet and
	press Cut/Eject to release)

Notes*: If the printer’s platen gap setting is set to Thick, a “H” will appear in the last space on the LCD display.

1.4.3 Panel Display Priority

High priority to low priority

„ Fatal errors/restart required

„Reset, timer IC rest/NVRAM clear

„Entering or in power-off sequence/transport preparation sequence

„Entering or in ink-cartridge-replacement sequence

„Cover open

Paper set lever released during operation

„Type B interface error No ink cartridge Wrong ink cartridge Ink out

„Roll paper and sheet sizes are different Paper jam

Paper set lever in release position Paper cutting error

Paper not straight Paper check error Roll paper end Paper eject error

„Initializing

Paper is too thick for cleaning Entering or in ink sequence Waiting for paper-initialization trigger Paused

Entering or in paper initialization Entering or in ink drying time-out Ink low/Maintenance required

„Processing data/printer ready

„ Out of paper

Product Description Control Panel 38