Epson 7000 Removing the Ink Cartridge Holder & Slots, Side frame, Ink tube cover Two Screws

EPSON Stylus Pro 7000 Revision B

4.2.3.9 Removing the Ink Cartridge Holder & Slots

The Ink Cartridge Holder is made up of six individual slots, one for each color of ink. The following instructions describe how to access and remove one of those slots.

„Before removing and ink cartridge slot, drain the ink as

C A U T I O N

7.Pull out the cables through the opening in the L Side frame, and remove the cables from the four clamps.

L Side frame

A D J U R E Q U

described in the Clean Head section of “Adjustment Menu” on page 174.

„To manually perform an initial ink charge, see “Cleaning Menu” on page 194

After disassembly and reassembly of the cover-open sensor, perform the cover-open sensor adjustment as described in “Cover Open Sensor Assembly” on page 200.

cable-opening

Cable clamps

1.Drain the ink as described in the Clean Head section of “Adjustment Menu” on page 174.

2.Remove the R Side Cover as described in “R Side Cover Removal” on page 114.

3.Remove the L Side Cover as described in “L Side Cover Removal” on page 116.

4.Remove the I/C Holder Cover as described in “I/C Holder Cover Removal” on page 116.

5.Remove the H Top Cover as described in “H Top Cover Removal” on page 117.

6.Remove the Cover-Open sensor cable and six Ink Cartridge sensor cables from the C299MAIN board (refer to Table 4-4, “C299MAIN Board Connectors,” on page 123 for details), and then remove the cables from their harness clamps.

Figure 4-49. Ink Sensor Harness Removal

8.Remove two screws (CPP M3x8) securing the ink tube cover and remove the cover.

Ink tube cover

Two

screws

Figure 4-50. Ink Tube Cover Removal

Disassembly & Assembly Disassembly Flow 137