Epson 7000 Removing the Cover Sensor Assembly, Screws M2x12 Cover Sensor Cover SW Assembly Holder

EPSON Stylus Pro 7000 Revision B

4.2.3.24 Removing the Cover Sensor Assembly

1.Perform the Steps 1 to 13 in “I/C Holder Cover Removal” on page 116.

2.Separate the harnesses for the Cover Sensor Assembly from the six harness connectors for the Ink Cartridge Sensor and harness bundle for the Cover Sensor Assembly.

3.Remove the two (CP(W) M2x12) screws securing the Cover Sensor Assembly and Cover SW Holder, and remove the Cover Sensor Assembly.

Screws (M2x12)

Cover Sensor

Cover SWAssembly

Holder

Figure 4-83. Removing the Cover Sensor Assembly

A D J U R E Q U

Perform the necessary adjustment listed in Table 5-2 in Chapter 5. This adjustment is required to make the Cover Sensor Assembly work interlocking with the close/open status of the Front Cover.

Disassembly & Assembly Disassembly Flow 155