Epson 7000 service manual Maintenance Call nnnn, Errors, No Paper Loaded

EPSON Stylus Pro 7000 Revision B

	Table 3-6. Maintenance Call nnnn
Item	Description
LCD	Maintenance Call nnnn
	nnnn = the replacement part code (see “Service Call 00000100”
message
	on page 93)
LED indicator	No change.
status
	Maintenance required. The corresponding part described by the
Details	nnnn has almost reached the end of its effective life. Service is
	required.
Recovery	Replace the old part(s) with new ones (Maintenance Kit 1054038)
	and reset the corresponding counters (Waste Ink and Cleaning).

ERRORS

Error messages appear on the LCD to notify the user that the printer cannot print properly under the current conditions. When an error message appears, printing stops and data transfer from the host PC stops. (The parallel interface signal = /ERROR -> “LOW” and BUSY -> “HIGH” and data cannot be entered.)

	Table 3-7. No Paper Loaded
Item	Description
LCD	No Paper Loaded
message
LED indicator	Paper Check indicator is on
status
	No paper loaded or the end of the roll paper.
	When printing on roll paper, if the Paper End sensor detects the
	end of the roll paper, paper feeding stops and the paper is held
Details	in place.
	When printing on cut sheets, if the Paper End sensor detects the
	end of the paper, printing as well as feeding stop and the paper
	is held in place.
	Load paper.
	For cut sheets, remove the printed sheet and load a new one.
	After loading the new sheet, the error is cleared. If data from the
	previous print job remains, the data is printed on the new sheet
Recovery	according to the original paper-size data.
	If this error occurs even if paper is properly loaded, check the P-
	REAR sensor for obstruction or dust. Also make sure there is no
	foreign material blocking the hole in the Paper Guide U where
	the P-Rear sensor is located.

Troubleshooting Troubleshooting Using the Error Messages 86