Epson 7000 service manual Side Cover Removal, Panel Unit, Hook, Lever opening cap

EPSON Stylus Pro 7000 Revision B

2.Remove the FFC cable from the connector and hook.

Panel Unit Connector

Hook

FFC

Figure 4-5. Panel Unit Removal 2/2

When replacing the control panel and FFC, make sure you push the FFC cable slack inside and towards the rear of the printer to avoid interfering with carriage movement.

4.2.1.2 R Side Cover Removal

1.Remove the control panel unit as described in 4.2.1.1 “Panel Unit Removal”.

2.Open the roll paper cover.

3.Push back the Paper Set Lever to the released position, remove two black screws (CBP: M4x10) from the lever handle, and remove the handle.

4.Using a (-) driver or similar tool, remove the lever opening cap. The cap may fall through the hole, so it is recommend you secure the cap between your finger and the driver as you remove the cap.

Paper Set Lever in release position

Lever opening cap Two screws

Figure 4-6. Paper Set Lever Handle Removal

Disassembly & Assembly Disassembly Flow 114