Epson 7000 service manual Control Panel, Buttons and Functions

EPSON Stylus Pro 7000 Revision B

1.4 Control Panel

This section describes the control panel, the buttons, the lights, and the way you make settings.

Figure 1-6. Control Panel

BUTTONS

All eight buttons on the control panel and their functions are described below.

Table 1-22. Buttons and Functions

Button		Function	SelecType	Power-On
(Second function)		(Normal)	Function	Function
Power		Power on/off	N/A	N/A
Pause	•	Switch -pause/ready	N/A	Maintenance
(Reset)	•	Reset (press 3 seconds)		Mode
	•	Enters SelecType mode
SelecType	•	Opens Cutter	Selects menu or
		Replacement Menu	major category
		(press for five seconds)
	Selects *1
Cut/Eject	•	Auto Cut	Confirms and saves
(Enter)	•	Cutter Off	setup values
	•	Sheet
				N/A
Paper Feed ↑	Feeds paper backward *2		Cycles backward/
			increases value
Paper Feed ↓		Feeds paper forward *3	Cycles forward/
			decrease value
Paper Source		Selects paper source	Selects item or
(Item)			minor category
Cleaning	Cleans both heads (press		N/A
	for three seconds)
Paper Source +				Maintenance
Cut/Eject +
				Mode 2
Paper Feed ↓
		N/A
Paper Source +				Firmware
Cut/Eject +				Update
Cleaning				Mode

Notes:

1:Interrupts ink drying and runs the specified operation.

2:1.27cm/second paper feed for 2 seconds after key is pressed. 7.62cm/second paper feed if pressed for over two seconds. Maximum feed of 20cm with one press of the button.

3:1.27cm/second paper feed for 2 seconds after key is pressed. 7.62cm/second paper feed if pressed for over two seconds.

Product Description Control Panel 34