EPSON Stylus Pro 7000

Revision B

 

 

Table 3-19. No Cartridge

Item

 

Description

 

 

 

LCD

 

No Cartridge

message

 

 

 

 

 

 

LED indicator

 

The Ink End indicator is on for the ink cartridge that is missing or

status

 

improperly installed.

 

 

 

Details

 

No ink cartridge installed or the ink cartridge is not fully installed.

 

 

 

 

 

Open the ink cartridge holder and install a new cartridge in the

 

 

empty slot. Do not use cartridges after removing them even one

Recovery

 

time.

 

 

If the cartridge is installed, and installed correctly, check the

 

 

operation and connection of the I/C detection sensor.

 

 

 

Do not insert used ink cartridges into the printer. Doing so will

C A U T I O N

cause the ink counter to function improperly.

 

 

Table 3-20. Option I/F Card

 

 

 

Item

 

Description

 

 

 

LCD

 

Option I/F Card

message

 

 

 

 

 

 

LED indicator

 

N/A

status

 

 

Details

 

An unsupported optional interface card is installed but cannot be

 

used.

 

 

 

 

 

 

 

Turn off the printer, remove the unsupported option card, and

Recovery

 

turn the printer back on. Install a supported option card if

 

 

necessary.

 

 

 

 

 

Table 3-21. Remove Paper

Item

 

Description

 

 

 

LCD

 

Remove Paper

message

 

 

 

 

 

 

LED indicator

 

Paper Check LED is on.

status

 

 

 

 

Paper is too thick to allow for head cleaning.

Details

 

The currently loaded paper is too thick to allow for timed

 

 

cleaning.

 

 

 

 

 

Move the Paper Set Lever to the release position, remove the

 

 

paper, and return the Lever to the set position. Cleaning starts

Recovery

 

and “Please Wait” appears on the LCD panel. When “No Paper

 

 

Loaded/Load Paper” appears, reload the thick paper to begin

 

 

printing.

 

 

 

 

 

Table 3-22. Cannot Print

 

 

 

Item

 

Description

 

 

 

LCD

 

Cannot Print

message

 

 

 

 

 

 

LED indicator

 

Same as before this error arose.

status

 

 

 

 

Cannot perform test print.

 

 

Due to one or more of the following reasons the printer cannot

 

 

print a nozzle check pattern, status sheet, PG adjustment pattern,

 

 

or paper thickness pattern:

Details

 

1) No paper loaded

 

 

2) Ink cartridge missing

 

 

3) Paper recognition error

 

 

This error appears on the LCD panel for about three seconds,

 

 

and then the display returns to its previous state.

 

 

 

Recovery

 

Exit SelecType mode and clear the error that appears on the LCD

 

panel. Then return to SelecType mode and print.

 

 

 

 

 

Troubleshooting

Troubleshooting Using the Error Messages

91

Page 91
Image 91
Epson 7000 service manual No Cartridge, Option I/F Card, Remove Paper, Cannot Print