Epson 7000 service manual Disassembly of the Waste Ink Box, Waste ink Box clamp Three hooks

EPSON Stylus Pro 7000 Revision B

4.The waste ink box clamp is held on by hooks. While pulling out the hooks to release them, remove the clamp from the box.

Four layers	Six layers of
of pads	pads

Waste ink

box clamp

Three hooks

Figure 4-31. Disassembly of the Waste Ink Box

5.Remove the old waste ink pads and dispose of them properly.

C H E When replacing the Waste Ink Pads, prepare a vinyl bag

PO I beforehand for disposal of the Pads.

6.Insert new waste ink pads, and re-install the Waste Ink Box in the printer.

A D J U When replacing the Waste Ink Pads, the following adjustment

RE Q U procedures are required. See “Maintenance Mode 2” on page 50.

„INIT. WASTE INK

„INIT. CLEANING

To reassemble the waste ink box and related parts, follow the above steps in reverse order and make sure you keep the following in mind:

„Four pads in the lower side, six pads in the upper side

„The waste ink tubes should be inserted into the box so that the ends are about 20mm (a little under one inch) from the bottom of the box.

„After inserting the waste ink tubes the proper distance from the bottom, properly attaching them to the notches in the clamp, push any tube slack through the frame towards the pump assembly.

„Make sure the tubes are not twisted or pinched.

„Make sure the tubes do not interfere with carriage movement.

This tube is	This tube is loose
correctly secured	and may cause
	carriage
	movement errors

Disassembly & Assembly Disassembly Flow 127