Epson 7000 service manual Cleaning Menu, Counters Reset by Counter Clear

EPSON Stylus Pro 7000 Revision B

COUNTER CLEAR

This function resets (to the original condition) the following counters which are stored in memory on the Main Board.

Table 5-14. Counters Reset by "Counter Clear"

Counter	Reset Value
Protection Counter A/B	0
Ink Volume Counter Rb/ Ry/ Rx/Rz	0
Consumed Ink Counter Cb/ Cy/ Cm/ Cc/ Cll/ Clc	0
Power Cutoff Timer T2	0
Accumulated Prints Timer	0
CL Timer	0
CL Timer 3	0
CL Flag	0
Initial Charge Flag	1*
Periodic Pseudo-Vacuum Flag	0

Note *: "1" means the flag is set, and the next time power is turned on the printer will perform an initial ink charge.

Before clearing the Waste Ink Counter or the Consumed Ink

C A U T I O N

Counter, make sure you replace the following parts with new parts.

„ Waste Ink Pads

„Flush Box

„Pump Assembly

„Cap Assembly

„Head Cleaner

The above parts are provided as [Maintenance Kit, SP-7000 1054038].

5.4.3 Cleaning Menu

Using this menu you can select a cleaning mode and initiate that cleaning operation. Also you can select whether or not the printer performs the initial- cleaning cycle as well as forcefully start the initial-cleaning cycle.

[Pause] returns you to previous menu

[SelecType]		[Enter]
		Start the
Cleaning: Std.	KK0
		cleaning cycle
Cleaning: Std.	KK1

Cleaning: Std. KK2

Cleaning: Init. Fill

[Item]

Figure 5-41. Cleaning Menu Options

† Std. KK0 (CL1)
Normal cleaning cycle	Volume of ink cleared = low
† Std. KK1 (CL1’)
Strong cleaning cycle	Volume of ink cleared = medium
	rubbing = off
† Std. KK2 (CL2)
Strong cleaning cycle	Volume of ink cleared = high
	rubbing = on
† Init. Fill	Perform Initial charge sequence

Adjustment Self-Diagnostic Mode Menus 194