EPSON Stylus Pro 7000

Revision B

5.Remove one screw (CP(W) M3x6) securing the damper holder, unhook the ink tubes from the damper holder, and then remove the damper holder.

Ink tubes

Ink tubes

 

6.Pull out the dampers. To pull out the dampers, place the tip of a flat-head screwdriver or similar tool under the protrusion on the left side of a damper and steady the damper with the forefinger of your other hand. Gently but firmly pull the damper straight out.

C H E If you only need to replace one head, you only need to perform

PO I the following steps in regards to that printhead. B head = left side; B, C, M

C head = right side; LC, LM, Y

C A U Do not squeeze the dampers and try to only touch the edges of the dampers. If pressure is applied to the middle of the dampers, the ink inside will squirt out.

Damper

holder

One

screw

B head

C head

dampers

dampers

Figure 4-34. Damper Holder

Screwdriver

Figure 4-35. Damper Removal

Disassembly & Assembly

Disassembly Flow

130

Page 130
Image 130
Epson 7000 service manual Ink tubes, Screwdriver