Epson 7000 service manual Sight of the printhead ID when looking at the ID level, Properly, Head

EPSON Stylus Pro 7000 Revision B

7.Using round-nosed pliers, remove the “Tension Spring, 9.9” from the C head on the right.

10. Repeat steps 7 through 9 for the B head.

CH E „ When replacing the printheads, fold the flat cable behind

Tension Spring, 9.9

Printhead voltage ID

H Spacer screw

P O I	the printhead and make sure the printhead snaps fully
	into place. When properly installed, the printhead ID will
	be directly behind and at the same height as the PG Cam
	Shaft. If the PG Cam Shaft does not partially block the line
	of sight of the printhead ID (when looking at the ID level/
	from straight in front), the printhead is not installed
	properly.

„When attaching the dampers to the printhead, follow the same order, left to right, as shown on the control panel: K, C, M, LC, LM, Y.

Figure 4-36. Printhead Tension Spring and Screw Removal

8.Remove one screw (CB M3x6), also called the “H Spacer” screw, and then remove the printhead from the carriage.

9.Remove the flat cable from the back of the printhead.

FFC

C head

Figure 4-37. Printhead Removal

Disassembly & Assembly Disassembly Flow 131