Epson 7000 service manual Disassembly & Assembly Summary 109

EPSON Stylus Pro 7000 Revision B

WA R Danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacture. Dispose the used batteries according to government’s law and regulations.

CA U TRisqueI O Nd’explosion si la pile est remplacée incorrectment. Ne remplacer que par une pile du même type ou d’un type équivalent recommandé par le fabricant. Eliminer les piles déchargées selon les lois et les règles de sécurité en vigueur.

CA U „ Before servicing or performing maintenance on the printer, make sure you have enough space. If you need to move the printer, be sure the space you move to is safe.

„ Because the printer is much heavier than most printers (about 44Kg for the printer body/ 53Kg for the printer and stand), you need to take extra care. If you need to take apart the printer and stand or lift the printer, two people are necessary.

„After removing any of the ink related parts, double check to make sure all parts are secured; otherwise you’re going to be in big trouble.

„Ink may leak onto other printer parts or the printer basket when removing printer parts, so it is recommended to put a sheet or cloth under the printer, especially when working on or near ink-related parts.

„When working on the electrical circuit boards, be careful concerning static electricity which can cause damage to the board. It is recommended you use an anti-static wrist band or similar grounding device to prevent static electricity buildup.

„When removing/re-inserting the flat-cable (FFC) from/to a connector, make sure to pull/insert the cable at a 90 degree angle to the connector. Otherwise, internal contact of the leads may be damaged and this can cause a short-circuit.

„When replacing connector wires, be careful to replace the entire length of the wire exactly as you found it; rubbing against edges or moving parts can cause noise in the wires.

„The cutter blade is very hard and can damage or scratch printer parts, and it can also be chipped or damaged. Be careful when handling or replacing the cutter.

„If you have to loosen a screw that has blue screw-lock applied to its head, make sure you apply blue screw-lock again when reassembling.

Disassembly & Assembly Summary 109