Epson 7000 service manual Load XXX Paper, Load Paper, Paper JAM, Cover Open

EPSON Stylus Pro 7000 Revision B

LOAD XXX PAPER

†Problem

The selected paper source (according to the remote PP command) and the paper type selected on the control panel do not match.

†Solution

Load the correct paper or change the panel setting to match the type of paper loaded in the printer.

LOAD PAPER

†Problem

While paper is loaded, the Paper Release lever was pushed up to the Release position.

†Solution

„Make sure paper is loaded properly and push down the Release lever to lock the paper in place.

„If this error occurs even when the lever is down, in the Lock position, there may be a problem with the Paper Release lever sensor. Check the sensor operation, sensor connection, and board.

PAPER JAM

†Problem

A paper jam occurs when during printing, paper feeding, or paper cutting the carriage is not able to move properly (due to paper catching on some part). The printer determines a paper jam has occurred if the P-Front sensor and P-Rear sensors are in the “on” state but the CR motor is out of step or has overcurrent.

†Solution

„After removing the paper stuck in the printer, the “TURN OFF AND ON” message appears on the display. The printer is ready after you turn the printer off and back on again.

„If a paper jams occurs again after removing the original paper jam, check to make sure nothing is blocking the feed path or blocking the carriage.

„Make sure the tabs of the Lower Paper Guide are inserted underneath the metal that supports the subplaten.

COVER OPEN

†Problem

The front cover is open.

This error occurs when the cover is opened during carriage operation or a cleaning operation, causing the CR/PF operation and ink sequences to stop. If the cover is left open too long, the printheads may be damaged. (To avoid this problem, press the Pause button before opening the cover. But be aware that a stripe may appear on the printout indicating the different drying times.)

†Solution

„Close the cover as soon as possible.

„If the cover is fully closed when this error occurs, make sure the left and right cover-open sensors are correctly installed and are operating properly.

Troubleshooting General Errors 100