Epson 7000 Removing the Maintenance Assembly, Harness Maintenance Base, Clamp For Panel

EPSON Stylus Pro 7000 Revision B

4.2.3.13 Removing the Maintenance Assembly

Two Sensor	Clamp
Harnesses

A D J U R E Q U

If you replace the waste ink absorbers because the service call error 0000100 occurs, you need to replace the specified parts* in the Maintenance Assembly. After replacing them, be sure to initialize the following counters:

„Waste ink counter

„Cleaning unit counter

Pump Motor

ASSY.

*Parts to be replaced: Pump Motor, Cap Assembly, Pump Assembly, Cleaner Head, and Flushing Box Assembly

NOTE: The above mentioned parts are available as a kit: [Description] MAINTENANCE KIT

[Parts code] 1054038

When you replace the Maintenance Assembly, ink may spill

C A U T I O N

from the ink tube connected to the pump assembly. Therefore, wipe the ink around the ends of the ink tubes preliminarily.

1.Remove the R Side Cover as described in “R Side Cover Removal” on page 114.

2.Remove the Rear Cover as described in “Rear Cover Removal” on page 118.

3.Disconnect the harness for the Pump Motor Assembly from its connector on the main board, and take the harness out from the hole in the R side frame.

4.Release the one Pump Motor Assembly harness and two sensor harnesses from the clamp on the Maintenance Base Assembly.

Harness

Maintenance

Base

Figure 4-63. Removing the Harnesses - 1

5.Release the panel FFC and CR FFC from the cable clamps at the back and bottom of the Maintenance Base Assembly, respectively.

Clamp

(for Panel

FFC)

Clamp (for CR

FFC)

Figure 4-64. Removing the Harnesses - 2

Disassembly & Assembly Disassembly Flow 143