Epson 7000 Removing the Cutter Solenoid, Cutter shaft, Cutter cap, Cutter not, Shown

EPSON Stylus Pro 7000 Revision B

4.2.3.6 Removing the Cutter Solenoid

1.Remove the cutter housing as described in “Removing the Cutter Housing” on page 133.

2.Push the cutter down (second tab from top) while moving the cutter cap (first tab from top) to the right to release it from the CR lock guide. Remove the cutter and cutter spring.

3.Remove the cutter cap, cutter solenoid core, and cutter solenoid spring.

Push out the cutter solenoid from below

		CR lock
		guide
Cutter
solenoid		Cutter
screws
		solenoid
		core
Cutter shaft	Cutter	Cutter cap
(cutter not	solenoid
shown)	spring

Figure 4-46. Cutter Solenoid Removal

After reassembly of the cutter housing, perform an auto cut operation to make sure 1) the cutter correctly disengages the CR lock and 2) the cutter correctly cuts the paper. If either operation is not satisfactory, the

4.Remove two screws (CP(W)M3x6) securing the cutter solenoid, and then using a (+) driver or similar tool, push the solenoid out from underneath the Cutter Assembly.

Disassembly & Assembly Disassembly Flow 135