Epson 7000 Removing the Cap Assembly, Cap part, Assembly Tubes connect, Here, Screw M3x6

EPSON Stylus Pro 7000 Revision B

4.2.3.15 Removing the Cap Assembly

1.Remove the Maintenance Assembly as described in “Removing the Maintenance Assembly” on page 143.

2.Remove the four (CUPS M4x3) screws securing the R Side Frame Sub Assembly and remove the R Side Frame Sub Assembly.

C A U Check for the points below when removing/mounting the Cap Assembly.

„Push the cap part down to the valve part and check that

the cap part rebounds with spring force.

„Check that the valve part is not dislocated.

Screws (M4x6)

R Side Frame

Sub Assembly

Screws

(M4x6)

	Valve
Cap part	part

Figure 4-70. Removing the R Side Frame Sub Assembly

3. Remove the one (CUPS M3x6) screw securing the Cap Assembly,Figure 4-72. Cap Assembly

disconnect the two tubes from the Pump Assembly, and remove the Cap
Assembly.
Tubes connect	Cap
here.
	Assembly

Screw (M3x6)

Figure 4-71. Removing the Cap Assembly

Disassembly & Assembly Disassembly Flow 147