Epson 7000 service manual Removing the Prear Sensor Assembly, Removing the Paper Guide U

EPSON Stylus Pro 7000 Revision B

4.2.3.23 Removing the P_REAR Sensor Assembly

1.Remove the R Side Cover as described in “R Side Cover Removal” on page 114.

2.Remove the L Side Cover as described in “L Side Cover Removal” on page 116.

3.Remove the I/C Holder Cover as described in “I/C Holder Cover Removal” on page 116.

4.Remove the H Top Cover as described in “H Top Cover Removal” on page 117.

5.Remove the Rear Cover as described in “Rear Cover Removal” on page 118.

6.Disconnect the harness for the P_REAR Sensor Assembly from its connector on the main board and drop the harness in the hole on the right.

7.Push the paper hold lever down to the front.

8.Remove the five (CBS M4x6) screws securing the Paper Guide U, and remove the Paper Guide U by slowly taking it out toward the upper front.

NOTE: When removing/installing the Paper Guide U, be careful not to mar the P_REAR Sensor Assembly with the edge of the sensor inspection window.

9.Remove the two (CP(W) M2x8) screws securing the P_REAR Sensor Assembly and remove the P_REAR Sensor Assembly.

NOTE: P_REAR Sensor Assembly position is adjusted at factory. Therefore, be sure to mark its current position before removing the screws.

AD J U If you replace the P_REAR Sensor Assembly, perform the R E Q U necessary adjustment listed in Table 5-2 in Chapter 5.

Paper Guide U	Screws
	(M4x6)

Screws (M4x6)

Screw	Inspection
(M4x6)	Window for the
	P_REAR Sensor
	Assembly

Figure 4-81. Removing the Paper Guide U

Screws (M2x8)

P_REAR

Sensor

Assembly

Figure 4-82. Removing the P_REAR Sensor Assembly

Disassembly & Assembly Disassembly Flow 154