Epson 7000 service manual Necessary Tools, Front Bottom, Tool Part Code

EPSON Stylus Pro 7000 Revision B

CH E „ If you find it is necessary to perform service on a part not

P O I	described in this chapter, be sure to check the after-
	service parts situation before beginning the service.

„If you need to remove the ink tubes or other ink related parts, see “Transportation Mode” on page 53 to drain the ink before removing anything.

„If necessary (i.e. when transporting the printer) use the above mentioned mode to drain ink, install transportation fluid cartridges (P/N1045585), and then perform an initial ink charge with the fluid. Enter the transportation mode again to remove the fluid (user can do) and then perform initial ink charge with ink.

„The directional instructions in this chapter are given as if viewing the printer from the front. See the illustration below.

TopRear

L

4.1.2 Tools

This section lists the tools necessary to disassemble or assemble the printer.

Table 4-1. Necessary Tools

Tool		Part Code	Notes
(+) Phillips screwdriver #2			longer than 250mm is helpful
(+) Phillips screwdriver #1		commonly available
(-) Standard screwdriver		tools, no special tools	-
		necessary
Round-nosed pliers			-
Tweezers			-
		Comes with stand,	5.5 mm for stand assembly
Hex (Allen key) wrench		commonly available
			only
		tools also OK
#E589 torque wrench		B765106901	Tube lock tightener
(6mm x 1Kg)
#F733 Self Training Kit	1053426		CD-ROM based service tool
transportation fluid	1045585		Transportation fluid cartridges
cartridges, S46, recycle			= six units required
Maintenance Kit SP7000	1054038		Replacement parts for periodic
			maintenance

R

Front

Bottom

Figure 4-1. Directional View of the Printer

Disassembly & Assembly Summary 110