Epson 7000 service manual Adjustment Self-Diagnostic Mode Menus 186

1/2880 inch

"+" = toward HP and "-" = away from HP

Align the lines vertically

Make sure light cyan and light magenta are equal width without overlapping (see the illustration below)

EPSON Stylus Pro 7000 Revision B

1.Make sure "Bi-D" appears on the LCD, and press the Enter button.

2.After all the patterns print, "BiD, 200, N, B: vvv" appears in the LCD.

3.At this point, you need to check the vertical alignment of the lines on the printed test pattern.

„If all the lines are correctly lined up as in the above sample, (make sure "BiD End" appears in the LCD and) press the Enter button to finish.

„If some lines are not aligned, select the numbered pattern using the

Paper Feed +/- buttons. Correction increment: Correction direction: Aim:

#1~5, #7 = #6, #8 =

After you finish correcting a pattern, press the Enter button to print another test pattern of that number only with your new settings in effect.

4.Repeat the steps until all numbered patterns are aligned.

Figure 5-29. Bi-D Adjustment for Patterns #6 and #8

Adjustment Self-Diagnostic Mode Menus 186