Epson 7000 ADJ Rear Sensor Position, Please Set Cut Sheet, Printing Pattern Paper Width 627mm

EPSON Stylus Pro 7000 Revision B

ADJ REAR SENSOR POSITION

This function makes sure the P REAR sensor correctly detects the rear edge of cut-sheet paper to allow the user to print with the largest possible printable area but without printing off the edge of the paper and marring future printouts. The printer prints an A3-size test pattern. Using a ruler, measure the distance from the rear edge of the pattern to the rear edge of the paper, and then enter this measurement when prompted. This value is stored in the printer’s firmware to be referenced against the printhead nozzle position.

1.Make sure "Adj Rear Sensor Pos." appears, and press the Enter button.

2.Load A3-size paper in portrait (short edge first) orientation when you see the "Please Set CutSheet" message. After the paper initializes, press the Enter button to print the check pattern.

3.After printing is finished, measure the distance from the rear edge of the printed pattern to the rear edge of the paper. Press the Enter button until you see "RearSen. Pos. xx.xmm", and then enter the measurement in increments of 0.1mm using the item select (Paper Feed) +/- buttons. After entering the measurement, press the Enter button.

Please Set Cut Sheet

Load A3-size paper short edge first.

[Enter]

Printing Pattern
Paper Width	627mm
[Enter]		Enter the value
		with the Paper
RearSen. Pos.	+3mm	Feed [+] or [-]
			button.	End
		[Enter]
			adjustment/
			next menu

Figure 5-37. Rear Sensor Adjustment Operation

Input this

measurement.

Feed

direction

Figure 5-38. Rear Sensor Position Adjustment/Measurement

Adjustment Self-Diagnostic Mode Menus 191