Epson 7000 Removing the Release Sensor/PTHICK Sensor, Connector Sensor Bracket Screw M3x6 Hooks

EPSON Stylus Pro 7000 Revision B

4.2.3.21 Removing the Release Sensor/P_THICK Sensor

Right: Release Sensor that detects the paper hold sensor condition (set or released).

Left: P_THICK Sensor that detects paper thickness (normal or thick)

1.Remove the R Side Cover as described in “R Side Cover Removal” on page 114.

2.Remove the L Side Cover as described in “L Side Cover Removal” on page 116.

3.Remove the I/C Holder Cover as described in “I/C Holder Cover Removal” on page 116.

4.Remove the H Top Cover as described in “H Top Cover Removal” on page 117.

5.Push the paper hold lever down to the rear.

6.Remove the one (CUPS M3x6) screw securing the sensor bracket and remove the bracket along with the both sensors.

NOTE: Sensor bracket position is adjusted at factory. Therefore, be sure to mark its current position before removing the screw.

7.Remove the harness from the connector of the Release/P_THICK Sensor.

8.Unhook the sensor from the sensor bracket and remove the sensor.

AD J U If you move the sensor bracket position, perform the necessary R E Q U adjustment listed in Table 5-2, “Service Parts & Required

Adjustments,” on page 158.

P_THICK	Detection	Release
	flag	Sensor
Sensor

Connector

Connector

Sensor

Bracket

Screw (M3x6)

Hooks

Sensor

Figure 4-78. Removing the Release Sensor/P_THICK Sensor

Disassembly & Assembly Disassembly Flow 152